Power Door Lock Not Working On 2008 Dodge Ram

Posted on sep 25 2008.

Power door lock not working on 2008 dodge ram.

Could be the issue or the relay it self is bad. Even if you change the acuators the locks still will not work until the code is cleared. The most recently reported issues are listed below. Symptom summary the power door locks are all inoperative or a single door lock is inoperative.

Average repair cost is 200 at 62 150 miles. All the switches on all four doors will not work either. I read in a forum that it could be the relay that has a 25a fuse in it that. Power door locks do not work.

My power windows on a 2008 dodge ram 1500 will not close. Usual cause the power door locks utilize individual solenoids in each of the doors that activate the door lock mechanism. What a forked up way to build stuff. I took the wire harness out and tested it and it works fine.

The rear window still opens though. For a 10 relay gotta spend 500 1000 dollars to fix power door locks. Diagnose power door locks don t work properly. The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators.

The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working. Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob. The switch provides power to the door lock solenoids. Windows can still work but locks will all stop.

21 people found this helpful.