Trace the lever outline on the door s edge.
Pocket door handle installation.
Position the pocket door pull on the edge of the door backwards and mark the center using a carpenter s pencil.
Then put the hardware and door into the slider track.
How to install your pocket door hardware in 5 steps.
Check that the track is level so that the door rolls easily.
Mark the spots for the mounting screws using an awl.
Drill the mounting screw holes.
Step 1 read the directions.
Be sure to screw the brackets into the studs.
Measure up 36 inches from the floor.
Step 4 drill holes.
Step 2 position pocket door pull.
Then cut the exposed studs to make room for the new framing.
To install a pocket door start by removing the existing door and the drywall on one side of the wall.
The pocket door is to be closed almost all the way.
1 pull the door halfway open by grasping the edge of it with your fingertips.
Jun 23 2020 explore hartford bldg prod s board pocket door hardware on pinterest.
Use your pencil to mark the jamb of the door for the latch plate to be installed.
Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw.
Door knobs pulls lock sets other accessories hardware installation instructions and manuals resources from emtek products inc.
Step 3 mark the screw points.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
See more ideas about pocket door hardware pocket doors door hardware.
To use the locking lever turn the lever which is on the lock body at the side.
Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives.
You can install the door pull on any pocket door that s been previously installed.
Place a mark where this lever comes into contact with door jamb.
Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door.